These aluminum fire hose ramps are designed to maintain traffic while protecting up to a 2.5" diameter fire hose. The ramp performs the function of protecting hose, pipe, cable, fuel lines, etc. Specifications: Sold only in multiples of 12 feet: (6 pieces x 2 feet wide) which provides 12 feet of road coverage Position ramps at 30° diagonal across roadway so vehicles cross ramps one wheel at a time Aluminum construction Clip assembly means no tools required Included Clips - 10 to assemble one...

Replacement clips for the aluminum fire hose ramps FHR12. Set includes enough clips for 12 feet of the aluminum Fire Hose Ramps. Only compatible with FHR12 Fire Hose Ramps for 2 1/2" and smaller diameter hoses. Clips come in packs of 12. Use 2 clips per 2 foot section for joining up to 6 sections across roadway.

The dual 2 1/2" channel hose ramp is specifically designed to protect supply line and/or master stream hoses from interruptions or bulges due to vehicle traffic. Hose ramps can be bridged together with the included connectors and surface mounted to prevent movement during use. The ramp supports vehicles up to 20,000 lbs per axle and requires 4" of clearance. Each ramp spans 12" across the width of the roadway.

The heavy duty dual channel encloses stream hoses up to 3" in outside diameter, preventing bulges that are created by heavy traffic running over the lines. The Dual Channel Hose Bridge is 5" high and each side has steps which increase at 1" increments that feature reflective yellow safety strips and glass bead reflectors that provide greater visibility in low light conditions. Works great inside and out at warehouses, construction sites, or on fire calls.

The 2-channel hose ramp is designed to hold hose lines with a 4" outside diameter, allowing vehicles with at least a 5 1/4" clearance to drive over the ramp, reducing the chances of hose bulges. Constructed with industrial strength thermoplastic rubber that supports up to 20,000 lbs per axle. Includes two connectors so ramps can be connected side to side to cover more area. Connectors have pre-drilled holes to permanently mount ramps together.

The Bridge Set can protect up to 5 hoses. There are openings for two 5 inch hoses, two 4 inch hoses and two 3 inch hoses. HBS will build 2 separate ramps (one for each tire). Each ramp is 24" wide across the roadway and 70" long in direction of travel. Each ramp is composed of 2 pieces that are 24" W x 35" L x 6 3/4" H that link together. HBS does NOT include joiner clips to join 2 ramps together side-by-side. These are sold separately as item HBS-HJ Single Ramp Dimensions: Width - 24" (across...

Fire Jose Bridge joiners are used on product HBS to link 2 ramps together side-by-side. Joining 1 x HBS requires 2 joiners. Joining 2 x HBS requires 6 joiners. Download Spec Sheet

Fire Hose Bridge Extenders are placed between the 2 pieces of the HBS Fire Hose Bridge to create a flat top surface. This allows lower clearance vehicles to more easily clear the hose ramp without grounding. HBS-EXT includes 2 flat extenders; one for each ramp in the HBS Fire Hose Bridge. Does NOT include the HBS bridge. Download Spec Sheet ...